This wrecker has the functions of lifting, pulling, lifting, etc. It is convenient, quick, good-looking, safe and reliable. This truck wrecker is widely used in highways, public security traffic police, airports, terminals, auto repair industry and highway companies, etc.
Wrecker truck equipped with lifting winch device and wheel bracket which can lift, towing, back load and transport.Widely used in road, police traffic, airports, docks, auto repair company, industry and highway departments, timely, fast clean-up accident, failure, illegal and other vehicles.
Road wrecker is used for safety salvage of vehicles subject to city road, suburb way, highway, airport and bridge road. It is suitable for medium and small-sized cargos, cars and other special vehicles, which are allowed within the technical parameters of this kind
The tow wrecker is called the road wrecker, also known as road rescue vehicle. It has many functions such as lifting, pulling and lifting traction.
The INT series is out integrated line of tow trucks commonly called wreckers. We have a wide range of products with 6 different models ranging for the small 3 ton to the massive 60 ton with a 3 stage boom.
The high-pressure cleaning suction truck is mainly used for cleaning urban sewers, pipeline sediments, dredging of dead corner mud trenches, cleaning industrial drainage pipes, wall surfaces, etc., and can also be used for watering, water transportation and road use. Can be used for fire fighting. The following is a brief introduction to the precautions for the operation of the high pressure cleaning suction truck.
1. Keep the vacuum pump suitable for the number of revolutions
The speed of the vacuum pump is too high, and the rotor heats up. If the speed is too low, it will cause additional impact on the machine and components, which will affect the service life. In order to achieve a suitable working speed, please adjust the best position of the hand throttle according to the pump type.
2. Self-unloading and turning on flat ground
Self-unloading and turning over the tank on an inclined road will cause distortion of various components and cause malfunction, and may cause a rollover accident. When the tank is self-unloading, the tank door is opened first. Before the dumping tank is unloaded, the locking bolt should be loosened first, and the rear tank door should be lifted to the required angle. When the tank is full, it is forbidden to close the rear tank door. The state lifts the tank, otherwise there is a danger of rollover.
3. When the oil pump and the vacuum pump take power, the engine idles and fully steps on the clutch pedal. After the power take-off switch is turned on, the clutch pedal is slowly released.
4. When the high-pressure cleaning suction truck is running, the vacuum pump and the oil pump are in a stopped state.
5. The truck must not be inhaled larger than the diameter of the hose and transport waste oil and dangerous materials.
6. Support rods and safety stops must be used when entering the tank bottom or overhauling in the state of self-unloading and turning tanks.
7. When driving high-pressure cleaning and sewage truck to transport dirt, the vehicle must drive at medium speed and slow speed, and should not make sharp turns and sudden braking, because the center of gravity of the non-wave plate in the tank is high. Obey the traffic rules and drive safely and civilly.